Owner's manual

Local Keyboard Setting
This parameter determines whether the OIT’s keyboard is enabled.
Factory Default: Enabled
To modify this parameter using
STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the Local Keyboard Enabled check box.
To modify this parameter in
Configuration mode:
1. At Keyboard:, use the OIT’s Period (.) key to enable or disable the local keyboard.
Refer to the Configuration Mode section in this chapter for more information.
To modify this parameter from the
host controller:
1. Use the Keyboard control command. Refer to Appendix A: Control Commands for
more information.
Key Click Setting
This parameter determines whether an audible key click occurs whenever a key is pressed
on the OIT’s keyboard.
Factory Default: Enabled
To modify this parameter using
STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the Key Click Enabled check box.
To modify this parameter in
Configuration mode:
1. At KeyClick:, use the OIT’s Period (.) key to enable or disable the local keyboard.
Refer to the Configuration Mode section in this chapter for more information.
To modify this parameter from the
host controller:
1. Use the Keyboard control command. Refer to Appendix A: Control Commands for
more information.
Chapter 1: OIT Configuration 16
1010-0101, Rev. 00