Instruction Manual

HMC7000 Series I/O Module Guide
Phone: [phone] • Fax: [phone] • Email: [e-mail] • www.maplesystems.com .
1010-1043 Page 70 of 85 Rev. 02, 11/08/2013
6. Enable the HSC Reset Bit by setting M00241 (Channel 1) or M00401 (Channel 2). Or by setting Reset Pin
X4 (Channel 1) or Reset Pin X5 (Channel 2). This will cause the HSC current value to reset back to 0 and
the output Y0 (Channel 1) or output Y1 (Channel 2) will reset (clear) to 0.
7. To start the process again, simply reset (clear) the HSC Reset Bit and set the HSC Enable Bit. Note: if the
HSC Enable Bit is still ON, you must reset (clear) this bit, and then set it again.