Installation Guide

4. Mix thoroughly with a low-speed mixer (at about 350
rpm) for about 3 to 5 minutes, or until obtaining a
smooth, creamy, homogenous paste consistency and a
uniform shading of the colored grout.
5. Allow the grout to sit (“slake”) in the container for about
3 to 5 minutes.
6. Remix for about 1 to 2 minutes without adding more
liquid or dry powder.
Note: Applicators desiring a heavier grout consistency may
withhold 3 to 6 U.S. oz. (89 to 177 mL) of Grout Maximizer
from the mixture, and then add enough Grout Maximizer to
achieve the preferred consistency before completing the
initial mixing.
MAINTENANCE
• Enhancedstainresistanceisavailablewithimmediate
cleaning of staining agents and proper maintenance.
• Spillsshouldbewipedupimmediatelyandscrubbed
with warm water, mild detergent and a white nylon
scrubbing pad or cleaning brush for at least 1 minute
before a clean-water rinse.
• Routineeverydaycleaningispermissiblewithneutral-
pH cleaners.
• Grease/soapbuildupstainsrequirealkaline-based
cleaners or degreasers.
• Efflorescenceremovalrequiressulfamic-basedacid
cleaners.
STAIN REMOVAL
1. Dampen the stained grout area with warm water.
2. Apply a cleansing agent to the surface and allow it to sit
for 30 seconds.
3. Scrub the area with a white nylon scrubbing pad or
cleaning brush for at least 1 minute and rinse with
clean water.
4. If additional scrubbing is required, re-apply the
cleansing agent and let it sit for several minutes before
scrubbing and rinsing.
PRODUCT APPLICATION
1. Read all installation instructions thoroughly before
installation.
2. Apply grout in accordance with the manufacturer’s
instructions.
3. Clean tools with water after each use.
PROTECTION
• Allowgrouttocureforatleast21daysbeforestarting
routine cleaning.
• Protectthefinishedinstallationfromheavytrafficfor
72 hours.
• Protectfromwaterimmersionandfreezingfor21days.
• Protectcontainerfromfreezingduringshipment.