Specifications
Known Design Marginality/Exceptions to Functional Specifications
www.ti.com
Advisory VREG: VREG 'Warn Lo/High' Feature Does Not Work as Intended
Revision(s) Affected 0
Details The VREG "Warn Lo/High" feature should not be used or enabled in the F28M35x
Revision 0 devices. Do not set the VREGWARNE bit in the MNMICFG register as it
could negatively affect the VREG output voltage.
Workaround(s) None. This will be fixed in the next revision of the silicon.
Advisory Temperature Sensor: getTempSlope() and getTempOffset() Functions are not
Available on TMX Silicon
Revision(s) Affected 0
Details The getTempSlope() and getTempOffset() functions are not available for use on TMX
silicon.
Workaround(s) None
Advisory EMAC: Resetting EMAC Controller Using SRCR2 Register Does Not Automatically
Reset the Ethernet PHY Via MII_PHYRST Signal
Revision(s) Affected 0
Details Resetting the EMAC controller by setting Bit 28 of the SRCR2 register does not
automatically reset the Ethernet PHY that is connected to the controller via the
MII_PHYRST function on the IO pin.
Workaround(s) The microcontroller signal or pin connected to the Reset pin on the Ethernet PHY should
be configured as a GPIO instead of as an MII_PHYRST peripheral pin; and the GPIO
must be toggled before resetting the EMAC controller. Toggling the GPIO pin (HIGH →
LOW → HIGH) will reset the PHY, assuming the reset for your PHY is an active-low
signal.
Advisory System Control: Clock Configuration Should Not be Changed When There are
Pending/On-going Accesses to Shared RAM (Cx and Sx) or to Analog Subsystem
Revision(s) Affected 0
Details If the clock configuration is being changed (e.g., changing the clock divider for
Cortex™-M3) when there is a pending/on-going access to Shared RAM (Cx/Sx) or to the
Analog Subsystem, the access could generate an error.
Workaround(s) Software should ensure that there is no pending/on-going access to Shared RAM or to
the Analog Subsystem when the clock configuration is being changed.
16
F28M35x Concerto MCU Silicon Errata SPRZ357B– August 2011– Revised January 2012
Submit Documentation Feedback
Copyright © 2011–2012, Texas Instruments Incorporated










