Use and Care Manual

8
TIMER
The TIMER has adjustable seng at range from 1 hour to 8 hours and OFF. As shown the
following: 1h-2h-3h-4h-5h-6h-7h-8h-OFF. If the digital display turns on and nothing happens
within 10 seconds, the digital display will auto shut off. Once you have set the mer, and the
mer is up, close all the funcons and enter standby mode. In this mode, you should touch the
power icon to restart the appliance.
INCREASE/DECREASE BUTTON
With the heater on, press the Increase/Decrease buon to change the desired temperature.
There are 11 temperature sengs:82℉-ON-64℉-66℉-68℉----80℉ (27℃-ON-18℃-19℃
-20℃----26℃)
BATTERIES REPLACEMENT
NOTE:
·Do not mix old and new baeries.
·Do not mix alkaine, standard (carbon zinc), or rechargable (nicad, nimh, etc.) baeries.
·Do not ingest baeries.
CAUTION:
·Always purchase the correct size and grade of baery most suitable for the intended use.
·Replace all baeries of a set at the same me.
·Clean the baery contacts and also those of the device prior to baery installaon.
·Ensure the baeries are installed correctly with regard to polarity (+ and -).
·Remove baeries from equipment which is not to be used for an extended period of me.
·Remove used baeries promptly
TROUBLESHOOTING
Fault code Fault Cause Soluon
E1 The heater overheang
E2 NTC is defecve. Call aer-sales service.
Call aer-sales service.
The heater not working.
If the vents are dirty or clogged. Unplug the power,
clean the dust and debris of the vent area. Wait for 5
minutes, plug in and turn on the heater. If the heater
sll don't work, please call aer-sales service.
E3