Use and Care Manual

7
OPERATING INSTRUCTION
On the top-right of the electric fireplace is the mechanical control panel. This panel contains
the buons to properly operate the electric fireplace. The buons on the remote control func-
on in the same way. The remote control has an effecve range of up to 6 m.
NOTE: The remote control is intended only for
the funconal operaon of the product, It can
not lock/unlock the heang funcon！
Digital Display
POWER
The POWER buon turns the appliance on or off. It has a memory funcon; the buon turns
off all funcons at once but retains the sengs in the memory (except mer). By pressing the
buon again, the unit will turn on at the same sengs. If the TIMER has set & me has expired
all funcons will stop. Press the POWER buon start the appliance.
FLAME
The FLAME control switch manages the flame brightness. There are 4 brightness levels and an
off posion. Each me the FLAME buon is pressed, the intensity of the flame decrease. When
adjusng the FLAME buon, a number indicang the brightness of flame will be visible on the
digital display. Aer turning on digital display, if nothing happens within 10 seconds, digital
display will turn off.
HEATER
The HEATER buon turns the heater on and off. When in ON posion, press and hold the
HEATER buon 5 seconds and enter temperature adjustment mode(Note: This can't be set
with the remote control). There are 11 temperature sengs:82℉-ON-64℉-66℉-68℉----80
℉ (27℃-ON-18℃-19℃-20℃----26℃) Aer the temperature is selected the digital display
will flash 5 mes and exit from seng status. Aer turning on the digital temperature display, if
nothing happen within 10 seconds, the digital display will expire.
Temperature unit convert funcon: With the heater is ON the posion, press and hold the
power icon for 5 seconds, current temperature unit display will flash 3 mers and convert to
another temperature unit (Note: This can't be set with the remote control).
Lock & unlock heater funcon: press and hold the heater icon for 10 seconds, the ember bed
will flash 6 mes, indicang that the heater funcon is locked. To unlock the heater funcon,
just repress and hold the heater icon for 10 seconds again, then the ember bed will also flash 6
mes indicang the heater funcon is unlocked and to recover the original states which you
have set (Note: This can't be set with the remote control).