Service manual

5
Step 6. Drill an appropriate sized hole for the marine connector (part 860010) using the template found in the
package. Connect one end of the 4/3AWG cord to the marine connector. Mount the connector as shown in the picture.
Connect the other end of the 4/3 cord to the surface mount 14/50 receptacle. Secure the 14/50 to the metal vent
chamber as in the pictured in Step 8, below. There are screw holes at the top of the vent chamber; you don’t need to
puncture the chamber to get a secure fit.
Step 7. Remove the screws holding the plastic liner on the left rear side of the cargo bay and expose the metal below.
Drill a 7/8 inch hole in the left rear underside of the RAV, as pictured below. Insert one side of the conduit from
under the car through the hole, and then guide it up behind the rear audio speaker so that it protrudes through the
access panel removed in Step 5.