Service manual

copper fragments end up there. Attach the end of the black wire to the negative (“-”) terminal of the GE breaker.

Place the protective wire covering along the length of the red wire. Cable strap the wire to hold it in place.

Step 27. Turn the breaker “ON” (red is exposed when on; green when off).

Step 28. Replace the cover on the electronics compartment. Using the torx wrench tool, tighten down the screws that

hold it in place.

Step 29. Place a liberal amount of silicon seal on and around the area where you cut the 1 inch hole in the rubber

boot. Insert some silicon in the end of the conduit as well to prevent moisture from entering.

Step 30. Replace the negative terminal of the 12volt battery system, then close the hood of the car.

Step 31. Re-insert the traction battery service plug. Replace the cover of the service plug area, making sure that it is

properly latched into place.