Service manual

11
Step 21. Solder an eye terminal to one end of the red wire trimmed off in Step 20.
Step 22. Solder an eye terminal to one end of the black wire trimmed off in Step 20.
Note: Perform the next two steps exactly as indicated. Do not attempt to connect your cables to any other terminals
other than the ones indicated, even though it might appear to make sense to do so. Connection as indicated is
necessary for the RAV4-EV’s computers to be aware of the power from the PFC-50.
Step 23. Using a 12mm socket, remove the nut holding down the top (positive, usually taped with red tape) traction
battery lead. Insert the eye terminal you just soldered to the red cable on the bolt. Replace the nut and tighten. The
picture below shows the bolt after the nut has been removed. Inspect the connection to ensure that no metal from
either the traction battery eye terminal or the eye terminal you have just installed is in contact with anything else
nearby.