Service manual

10
Step 19. Insert the red and black wires through this opening, and carefully and gently pull the wire inside the
electronics compartment. Do not apply force to the plastic connectors near the boot opening. Route the wire around
the lower right corner of the electronics compartment as in the picture.
Step 20. Measure and trim the wires so that there is enough length to reach the breaker positioned as in the picture.
Terminate these wires on the “line” side of the second GE breaker. Note that this means that the breaker will be
upside down as you are facing it from the front of the car. Be sure that the red wire is connected to the (“+”)
terminal of the breaker and the black wire is connected to the (“-“) terminal.