Owner`s manual

7
•Chargers with 8A or newer control board have 2 additional peak voltage set
points and one additional amperage set point which can be enabled via the
4pin RJ connection on the blue face plate
Dimensions, Specifications and Mounting
The PFC-20, PFC-30 and PFC-40 chargers weigh approximately 18 pounds (8.2 kg)
The maximum outermost dimensions including foot flanges and protrusions are
approximately: 14” L x 10.5” W x 5.75” H (358mm x 264mm x 145mm)
Input Voltage Range : 100 to 240VAC 40-80Hz computer grade pure sine wave.
Output Voltage Range : 12 to 450VDC ( +/- 1 volt )
Operating Temp Range : -20° F to +120° F ( -28.8° C to +48.8° C )
Power Consumption : Up to 9.6kW ~ PFC40 / 7.2kW ~ PFC30 / 4.8kW ~ PFC20
The 20, 30 or 40 nomenclature is indicative of how many amps that charger is rated
to draw from the AC input power line. Unlike some other chargers, this is the rated
continuous load and all units are thoroughly tested to their rated limits before leaving
Manzanita Micro. An optional multifunction panel mount meter is available which
displays the amount of current (amps) that the charger is drawing off the AC line as
well as the AC Line voltage, total wattage and power factor. This information allows
for fine tuning to get maximum power from wall outlets without tripping breakers and
it also provides a way to estimate charging time based on the watts being used.
The charger can be mounted in any orientation as long as it has adequate airflow
and is protected from sucking in moisture and debris. All chargers are designed to
automatically cut back current when they exceed their temperature limits. If the