Owner`s manual

24
figure 11. Correct RJ Cable Orientation
Step 6: Double check that the blue wire is to the right side with the tang
down and then take the RJ crimping tool in your right hand. With your left hand push
the cable with un-crimped plug into the 6-pin die on the crimping tool.
Step 7: While using your left hand to make sure that the RJ cable is firmly held
all the way into the connector, squeeze the crimping tool all the way with your right
hand to complete the crimp.
If you have a clear plug-end, you can look in and make sure that each of the 6 metal
pins sank all the way down into their respective wires. Give the connector a slight
tug to make sure that it is adequately fastened and now you have created a proper
reg bus RJ cable end.
Follow the same steps on the other end of the cable and you are done. NOTE!
When crimping the second end of the cable, notice that you’ll have to flip it over in
order to again orient the blue wire to the right when the connector tang is
facing down. (see figure 12. )