Owner`s manual

figure 07: DC Battery Side User-Built Example Power Cable

Now you should have a gray SB-50 connector with a positive and negative wire

coming out. (See figure 07) Use the appropriate lug or connector for your battery

terminal and connect it onto the other end of each cable. Connect the positive cable

to the most positive terminal of the battery pack. Connect the negative cable to the

most negative terminal of the battery pack. Double check that the polarity is correct

and then plug the battery pack SB-50 into the DC output SB-50 coming from the

PFC charger (see figure 08). Now the charger is connected to the pack and you are

ready to hook up the charger’s input power.