Specifications

CAUTION
Do not attempt to install a storage device or storage array unless you
have received training in electrostatic discharge (ESD) procedures and
have taken proper precautions against ESD. Wear an ESD grounding
strap properly connected to a known ground. An ESD strap is shipped
with each H9646 cabinet. Two ESD bolts for connecting grounding straps
are located in each H9A00 cabinet; one each in the second hole from the
top in both the front and rear right-hand mounting rail.
CAUTION
Storage devices must be environmentally stabilized in their protective
barrier bags at the site before operation. Failure to environmentally
stabilize the equipment may result in damage to the drive media or
electronic components. For more information about environmental
stabilization, see Appendix A.
5.3 Unpacking and Packing Equipment
This section explains how to unpack storage devices at the customer’s site and
how to pack equipment for shipment or storage. Figure 5–2 shows how the RA9x
disk drive is packed for shipment.
5.3.1 Unpacking Storage Devices
Complete the following procedure when unpacking equipment:
1. Check packaging for external damage.
2. Read and save any packing information.
3. Keep all receipts in case of damage or problems with the equipment.
Unpack the storage device using the following procedure:
1. Remove the shipping straps.
2. Open the container.
3. Remove and save the packing material.
WARNING
Do not use the cardboard handles to lift the storage device from the
shipping container. You may injure yourself or others or damage the
equipment. A disk drive can weigh as much as 31.8 kilograms (70
pounds) and a fully populated enclosure can weigh 40 kilograms (88
pounds). To prevent injury when lifting an object weighing more than
18.2 kgs (40 lbs), use at least two people or a Digital-approved lifting
device.
Storage Array Add-Ons and Upgrades 5–3