Specifications

Figure 4–4 I/O Bulkhead Support
COM-0118
CABINET
REAR
ACCESS
PANEL
PINS
BULKHEAD FRAME
WING NUT
BULKHEAD
SUPPORT
CABINET
REAR
BUSTLE
6. Place the bottom slots of the I/O bulkhead over the pins in the frame and
rotate it upward.
7. Fasten the captive screw in the center of the bulkhead to secure it to the
cabinet frame.
8. Connect the storage device power cords to the same receptacles on the
controller. This is necessary to ensure that phase balance is maintained.
(Refer to Figure 4–5.)
9. Connect the power controller power cord to the power source.
Removing and Replacing Cabinet Components 4–7