Specifications

Figure 4–2 H9646 Rear Panel
CABINET
REAR
BUSTLE
CABINET
REAR
ACCESS
PANEL
HEX
WRENCH
CXO-2131C
I/O BULKHEAD
PINS
HEX
FASTENER
1. Remove the cabinet rear panel. (See Section 4.1.2.)
2. Record both the external and internal SDI cables connections.
3. Disconnect all external SDI cables from the rear of the bulkhead.
4. Unfasten the captive screw in the center of the bulkhead. Rotate the
bulkhead out and down from the unit.
5. Remove the bulkhead by lifting it straight up until the bottom slots clear the
pins in the I/O frame.
6. Disconnect the internal SDI cables.
Use the following procedure to replace the I/O bulkhead:
1. Connect the internal SDI cables.
4–4 Removing and Replacing Cabinet Components