Specifications

3.7 Selecting the Line Input Voltage
Each storage device has a Line Voltage Selector switch that is to be set to the
local line input voltage, either 120 Vac (60 Hz) or 240 Vac (50 Hz). You are
responsible for setting the Line Voltage Selector switch to the appropriate voltage.
Use the following procedure to set the correct voltage:
1. On each storage device, set the Master On/Off switch or the circuit breaker,
shown in Figure 3–16, to the off (0) position.
2. On the SA7x enclosure, set all four drive power switches, shown in
Figure 3–17, to off.
3. Use a small screw driver to place the Line Voltage Selector switch on each
storage device to the input line voltage.
3–24 Installing a Storage Array