Specifications

Figure 3–6 Unloading the Cabinet
CXO-924A_S
• Keys to the cabinet front panel are taped to the outside of the panel.
Installing an H9A00 cabinet requires you to:
1. Remove the rear panel.
2. Install the filler panels.
3. Extend the sliding side panels.
4. Secure the filler panels to the sliding side panels.
The position of the rear panel is described in Section 3.4.3.
3.4.1 Rear Panel
Use the following procedure and see Figure 3–7 to assemble the H9A00 cabinet
rear panel:
1. Remove the rear panel. Use a #2 Phillips screwdriver to remove the four 10-
32 x 1/2-inch screws that secure the rear panel to the I/O bulkhead. Discard
these screws.
3–10 Installing a Storage Array