Specifications

Figure 5–37 SA900 Chassis Retaining Brackets
SHORT SEMS
PAN-HEAD
SCREWS
CHASSIS RETAINING
BRACKET
CXO-3939A-MC
TB1
ATTACH
RIGHT
OCP
ATTACH
LEFT
OCP
5.11.2 Installing the SA7x Enclosure
Use the following procedure to install the SA7x enclosure into a SA900 cabinet:
WARNING
The fully-populated enclosure, with four disk drives and a power supply,
weighs up to 40 kilograms (88 pounds) and can cause serious injury
if lifted improperly. If a lifting device is not available, two people are
required to lift and install the enclosure. One person can install the
enclosure if the disk drives an power supply are removed to lighten the
load. (Refer to the SA7x Enclosure Service Manual for instructions.)
1. Install the guide rail plate assembly in the disk drive location. (Refer to
Section 5.6.)
Storage Array Add-Ons and Upgrades 5–57