Specifications

3. Open the front cabinet door and remove the rear panel.
4. From the cabinet door, remove the bezel filler that corresponds to add-on
sequence position 2.
a. Remove the four U-clips securing the bezel filler to the door.
b. Remove the bezel filler.
WARNING
Use care in supporting the guide rail plate. It is heavy and awkward to
position within the cabinet. If possible, use two persons to support and
position the guide rail plate. The guide rail plate may cause injury if
dropped during installation.
Note
Removing the door latch in step 5 applies only to installing guide rail
plates in position 2.
5. Remove two mounting screws and kepnuts securing the door latch to cabinet
and remove the door latch.
6. Install the guide rail plate in add-on sequence position 2. Add-on sequence
position 2 corresponds to mounting hole numbers 65, 71, and 78 as shown in
Figure 5–17.
a. From the front of the cabinet, position the guide rail plate with the
mounting bracket to the front, making sure that the arrow on the
mounting bracket is pointing up.
b. Insert the two rear round stand-offs into the cabinet so that hole 71
becomes the center mounting hole in the guide rail plate.
c. While supporting the guide rail plate against the cabinet rear vertical
upright, extend the mounting bracket to engage the two front round
stand-offs into hole numbers 64 and 79 on the cabinet front vertical
upright.
Note
If installing in other than position 2, insert a shoulder screw in the middle
mounting hole.
d. Attach the door latch and secure with two mounting screws and kepnuts
in mounting holes 71, and 78.
e. From the rear, insert and tighten the three shoulder screws and
lockwashers in mounting holes 65, 71, and 78.
f. Insert and tighten two flathead screws through the top and bottom guide
rail plate holes to the two U-nuts mounted on the cabinet front vertical
upright.
Storage Array Add-Ons and Upgrades 5–29