Service manual

Replacing SA7x FRUs
7.6 Fan Assembly Removal and Installation
Figure 7–6 Installing the Fan Assembly
FAN
MOUNTING
SCREWS
(4 PLACES)
LATCH
FRAME
FAN
CABLE
FRAME
SHEET
METAL
CXO-2613B
3. Tighten the four mounting screws.
4. Connect fan connector J1 to TB2.
5. Reposition the SDI cables.
6. Slide the enclosure frame back into the cabinet and secure it in place with the
four mounting screws.
7. If applicable, retract the cabinet stabilizer foot.
8. Perform the checkout and power-up procedures explained in Section 7.10.
7.7 Remote OCP Cable Removal and Installation
This section explains how to remove and install one of the four remote OCP
cables in the SA7x enclosure.
Two remote OCP cables are routed from their associated drives down each side
of the frame and connected to TB2. These cables interface the disk drives to the
OCP (through TB2 and TB1).
Replacing SA7x FRUs 7–11