Installation guide

4.2 Single-Host Installation of an SF3xx Storage Array
Figure 4–1 Verifying the SF7x DSSI ID Switch Settings
Write
Protect
Ready Fault
DSSI
ID
Write
Protect
Ready Fault
DSSI
ID
d
i g i
t
a l
SHR_X1128B_89
1
2
e. Make sure that all drive dc power switches (lower half of the enclosure)
are in the out position. You have to replace the front bezels to do so.
WARNING
Adhere to electrostatic discharge (ESD) procedures at all times. Use
the ESD straps available with every storage array. The straps are
inside the rear door. For details see Section 3.3.
4–4 Installing an SF3xx Storage Array to a VAX 6000 System