Installation guide

I
Indicators, 3–37
Inspection
of DECArray300 storage array, 2–5
of ramps, 2–3
of shipped equipment, 2–1, 5–4, 6–3
Installation
disk drive, center level, 7–7
disk drive, lower level, 3–6, 7–8
disk drive, upper level, 7–7
disk or tape drive, center level, 3–6
disk or tape drive, upper level, 3–5
of DECarray, D–1
of disk ISE into Sx72–HK storage
enclosure, B–2
of magazine tape subsystem, 6–1
of SF3xx storage array, 4–1
of SF7x storage enclosure, 5–1
of Sx72–UK upgrade kit, B–1
SA300/H9643 cabinet system, 7–2
troubleshooting, 8–1
Installation with a VAX 4000
of DECarray, D–1
Installing left position RETMA chassis rail
assembly, 3–15
Installing left position universal chassis rail
assembly, 3–26
Installing right position RETMA chassis rail
assembly, 3–19
Installing right position universal chassis
rail assembly, 3–23
ISE errors, 8–14
K
KFMSA bulkhead connector
for dual-host configuration, 4–18
for single-host configuration, 4–8
Kick plate, cabinet, 3–5, 3–6, 7–8
removal and replacement, 3–13
L
Labeling cables
dual-host conversion, C–11
magazine tape subsystem installation,
6–24
SF7x installation, 5–43
Labeling the magazine tape subsystem,
6–24, 6–25
Labeling the operator control panel, 5–44
SF7x installation, 5–43
Labels, filling out
dual-host configuration, 4–20
dual-host conversion, C–13
magazine tape subsystem installation,
6–24
SF7x installation, 5–44
single-host configuration, 4–10
Labels, placement of
dual-host configuration, 4–20
dual-host conversion, C–15
on DSSI cables, 5–44, 6–25
on magazine tape subsystem, 6–25
on SF7x operator control panel, 5–44
single-host configuration, 4–11
LEDs
all blinking, 8–15
green blinking, 8–15
yellow on, 8–15
Lifting device
procedure for using, 3–29
M
Magazine tape subsystem
cabling
for dual-host configuration, 6–20
for single-host configuration, 6–14
in Sx300 storage array, 6–13
final verification, 6–27
installation
in Sx300 storage array, 6–2
installation procedure, 6–8
kit contents, 6–3
Index–3