Installation guide

D.1 Single-System Installation of an DECarray

Table D–2 DSSI Bus 0 Conﬁgurations

System Internal ISEs DECarray

Tape ISE Disk ISE Tape ISE Disk ISE

0 0 0 or 1 up to 6

0 1 0 or 1 up to 6

0 2 0 or 1 up to 4

0 3 0 or 1 up to 4

0 4 0 or 1 up to 2

1 0 0 up to 6

1 1 0 up to 4

1 2 0 up to 4

1 3 0 up to 2

D.1.2.2 Completing the System Conﬁguration Sheet (Single-System)

At this time, you should be ready to ﬁll out the system conﬁguration sheet

(Figure D–5). The information from the system conﬁguration sheet is used to

ﬁll out the labels correctly for all DSSI cables, enclosure OCPs, and ISEs.

Note

Do not attempt to ﬁll out and place the labels until you have completed

the system conﬁguration sheet.

You can also refer to the inside cover of the SF Family Label Booklet (part

number 36–32882–01) for instructions on how to ﬁll out the labels.

Installing a DECarray with VAX 4000 Systems D–9