Installation guide

D
Installing a DECarray with VAX 4000
Systems
This appendix describes the steps to install the DECarray correctly and safely
with VAX 4000™ systems in two configurations:
• Single-system installation (Section D.1) where one CK–SF200–LP cable kit
is required per DSSI bus.
• DSSI VAXcluster
™
installation (Section D.2) where two CK–SF200–LP
cable kits are required per DSSI bus.
Perform the steps in the appropriate section only after you have completed the
installation of the DECarray as described in previous chapters.
Make sure that all precautions for site preparation have been completed.
Digital Multivendor Customer Services or trained installing personnel must
perform the step in the following WARNING:
WARNING
Hazardous voltages are in the storage array and in the components of
the storage array.
When performing any operation involving the power source, turn off
the power controls of all components and on the power controller.
Disconnect the power cable from the source outlet. Perform the
operation, then reconnect the power cable to the source.
Installing a DECarray with VAX 4000 Systems D–1