Installation guide

C.2 Conversion Procedure
2. Reconfigure the transition termination module (TTM) for split-bus mode by
first moving the small black jumper to the split-bus terminals, then moving
cable connectors to the right pair of sockets.
3. Push the SF7x inner drawer back in, replace the front cover door, and
tighten the four front door screws. To prevent pinching any cables, be sure
that all cables are dressed correctly.
Figure C–2 Changing an SF7x to Split-Bus Mode
THRU
TO OCP
J11
J4
J3
J2
SPLIT
SHR_X1111_89
J5
SPLIT-BUS MODE
Converting a Single-Host Configuration to a Dual-Host Configuration C–5