Installation guide

B.4 Bringing the New RF72 Disk ISEs On-Line

Refer to the KFMSA Module Installation and User Manual (EK–KFMSA–IM)

for the sections on conﬁguring a single-host and dual-host conﬁguration.

Note that you will be instructed by these sections to perform the following

tasks:

• Boot VAX/DS on the host systems.

• Attach the KFMSA modules in each system.

• Select each KFMSA module in each system.

• Run EVCXE or EVCXF.

• Modify certain parameters in the disk ISEs.

• Make sure that all modiﬁed parameters are recorded as permanent values.

• Verify the communication path with all ISEs on the DSSI buses.

After all of the above have been accomplished successfully, return the systems

and the Sx300 storage array to normal operating mode.

B–8 Installing an Sx72–UK Upgrade Kit