Installation guide

B.2 Installing the RF72 Disk ISE into an Sx72–HK Storage Enclosure
Take all possible ESD precautions when unpacking the RF72 disk
ISEs. Wear a correctly grounded ESD strap.
CAUTION
Only one Sx72 storage enclosure inner assembly should be extended on
the slide mount at a time.
The following steps describe how to install the two-drive Sx72–UK upgrade
into an Sx72–HK storage enclosure with two RF72 disk drives. The upgrade
includes the two RF72 disk ISEs to be installed in the two front positions of an
Sx72–HK enclosure.
1. To unpack an RF72 disk ISE:
a. Open the shipping carton.
b. Remove the disk ISE wrapped in the protective wrapper.
c. Open the protective wrapper and remove the disk ISE. Discard the
desiccant bags.
d. Place the disk ISE on the protective wrapper.
2. Install the RF72 disk ISEs.
WARNING
Take all possible ESD precautions when handling the RF72 disk ISEs.
Wear a correctly grounded ESD strap.
a. Remove the Sx72 storage enclosure front cover (see Figure B–1) by
loosening the screws and lifting the cover straight off.
b. Orient the RF72 disk ISE as shown in Figure B–2 and install the
disk ISE in the enclosure. Slide the disk ISE gently into place, while
holding all cables out of the way. Do not force the disk ISE.
Installing an Sx72–UK Upgrade Kit B–3