Installation guide

6.2 Cabling the Subsystem in Sx300 Storage Array Position
Figure 6–7 Installing the 42- and 70-Inch DSSI Cable (TF1)
SHR-X0141B-90-CPG
DSSI
CONNECTORS
AC RECEPTACLE
AC POWER
SWITCH
6.2.1.2 Cabling TF2
WARNING
Before performing the following steps, refer to the system documenta-
tion for the correct steps to perform an orderly shutdown of the system
that the Sx300 storage array is connected to.
1. Take the drives SF2 (if present) off-line before you proceed. To do so, first
take each ISE off-line by pressing the Ready buttons. Then press all the
Installing the Magazine Tape Subsystem in an Sx300 Storage Array 6–15