Installation guide

6.1 Steps to Install
Figure 6–5 Securing the Tube to the Weldment Brackets
SHR-X0132A-90
LOCK WASHER (2)
90-07651-03
1/2-INCH PHILLIPS
SCREW (2)
CHASSIS RETAINER (2)
74-35858-01
SLIDE MOUNT
HARDWARE
HERE IS
SAME AS
LISTED
ABOVE
1 1/2-INCH PHILLIPS
SCREW (2)
90-06079-03
90-06079-02
b. At the rear of the magazine tape subsystem, make sure that the ac
power switch is off or in the 0 position. See Figure 6–6.
c. Also check the factory set ac power on the magazine tape subsystem.
Model variants –AA are 120 Vac and model variants –AB are 220 Vac.
d. Place the subsystem in the head cleaning position (first mechanical
stop).
e. Mount the half bezel bracket to the tape system.
f. At this time, connect the ac power cord to the subsystem.
Installing the Magazine Tape Subsystem in an Sx300 Storage Array 6–11