Installation guide

6.1 Steps to Install
6.1.4 Installation Procedure
This section describes the step-by-step procedures for installing a magazine
tape subsystem in an Sx300 storage array.
Be sure to:
• Follow each step in order, and do not skip any steps
• Leave sufficient room to perform the installation (approximately 1.5 meters
to 1.8 meters [5 feet to 6 feet] front and rear of the array)
WARNING
Observe all ESD precautions and procedures.
An antistatic wrist strap is inside the front and rear doors.
CAUTION
Do not attempt to pick up or support the product by the rear of the
enclosure. Doing so will injure the person attempting the installation
or damage the power supply.
To maintain stability, extend only one SF72 storage enclosure or
magazine tape subsystem on the slide mounts at a time.
6.1.4.1 Preparing the Sx300 Storage Array
The following procedure describes how to prepare the array to receive the
magazine tape subsystem:
1. Place the magazine tape subsystem to be installed to one side, in front of
the cabinet.
2. Open front and rear doors of the Sx300 storage array.
3. Remove the front bezel panel that corresponds to the position of the Sx300
storage array you are installing.
6–8 Installing the Magazine Tape Subsystem in an Sx300 Storage Array