Installation guide

6.1 Steps to Install
Table 6–2 (Cont.) Magazine Tape Subsystem Kit Contents
Description Quantity Part Number
Chassis retainer 2 74–35858–01
10-32 Phillips (SEMS) 4 12–21368–03
Machine screw, Phillips, 0.500 2 90–06073–02
Machine screw, Phillips, 1.5 2 90–06079–03
Lock washer, external steel 2 90–07651–00
AC power cord, 8-foot 1 17–00442–03
DSSI cables, 42-inch, box-to-box 1 BC21Q–3F
Owner’s manual 1 EK–SF72S–OM
Installation guide 1 EK–Sx300–IG
Subsystem owner’s manual 1 Subsystem specific
Label booklet 1 36–32882–01
Note
DSSI cable retainer and weldment bracket of this kit are not used for
the Sx300 cabinet.
6.1.2 Where to Install the Magazine Tape Subsystem
The second & third level of the Sx300 storage array cabinet is used for
magazine tape subsystems. The subsystems install in numerical order. Facing
the front of the cabinet, note that position 4 is on the left and position 3 is on
the right.
6.1.3 Completing the System Configuration Sheet
Locate the system configuration sheet. If you cannot locate this sheet or if the
one that is available is either not filled out or filled out incorrectly, fill one out
immediately.
Refer to the KFMSA Module Installation and User Manual (EK–KFMSA–IM)
for an explanation of this sheet and how to fill it out.
6–4 Installing the Magazine Tape Subsystem in an Sx300 Storage Array