Installation guide

Table 6–1 Magazine Tape Subsystem Required Tool List
Description Part Number
#0 Phillips screwdriver 29–10991–00
#1 Phillips screwdriver 29–11001–00
#2 Phillips screwdriver 29–11005–00
1/8-inch slot screwdriver 29–10802–00
5/16-inch slot screwdriver 29–10960–00
1/8-inch hex key 29–26115–00
3/16-inch hex key 29–26118–00
11/32-inch nutdriver 29–10674–00
See Chapter 8 for tools or equipment recommended for use when
troubleshooting after a successful installation.
6.1 Steps to Install
The magazine tape subsystem that you are installing contains a tape
integrated storage element (ISE) and the tape cartridge loader assemblies.
This section contains several major parts. The first part explains the steps
necessary to do the following:
• Unpack, inspect for damage, and identify parts
• Determine where to install the magazine tape subsystem
• Read and fill out the system configuration sheet
The next part explains the steps to install the magazine tape subsystem itself:
• Prepare the array cabinet to receive a magazine tape subsystem
• Install the supporting hardware and magazine tape subsystem, and set the
DSSI ID switches
• Cable the magazine tape subsystem to comply with the DSSI bus cabling
conventions
The last part explains the steps to do the following:
• Power up the magazine tape subsystem, run the power-on self-test, and
run the configuration programs
• Label all cables and operator control panels
6–2 Installing the Magazine Tape Subsystem in an Sx300 Storage Array