Installation guide

5.2 Cabling the SF7x in Storage Array Position
4. Install a 70-inch DSSI cable (part number BC21R–5L) (see Figure 5–16).
Plug the other end of this cable into the leftmost DSSI connector at the
rear of the SF3.
5. For the cable to port 3, route the DSSI cable on the right side. For the
cable to port 11, route the DSSI cable under the cable retainer on the left
side.
6. Plug two 108-inch DSSI cables (part number BC21Q–09) into ports 3 and
11. Tighten the retainer screws on the 108-inch DSSI cables with your
fingers.
Figure 5–16 Installing the 70-Inch DSSI Cables (Position 3)
SHR-X0122-90
70 INCH
DSSI CABLE
108 INCH
DSSI CABLE
sx300
I/O PANEL
5–36 Installing the SF7x Storage Enclosure in an Sx300 Storage Array