Installation guide

5.2 Cabling the SF7x in Storage Array Position
Figure 5–6 Installing the OCP on the SF7x Enclosure
TTM CLIP
FASTENERS
OPERATOR
CONTROL
PANEL
OCP
CONNECTOR
ESD
WRIST
STRAP
FRONT
COVER
PINS
SHR_X1113_89_SCN
See Section 5.2.1 for instructions on how to cable the SF7x storage enclosure
in an Sx300 storage array configured for single-host. See Section 5.2.2 for
instructions on how to cable the SF7x storage enclosure in an Sx300 storage
array configured for dual-host.
Once the cabling of the Sx300 storage array is complete, each bus must be
connected to match one of the following eight buses. Figure 5–9 shows the five
possible single-host configurations, and Figure 5–10 shows the three possible
dual-host configurations.
Installing the SF7x Storage Enclosure in an Sx300 Storage Array 5–15