User manual

2. For operation:

• Pull the levers for leg angle adjustment

• Adjust the legs, until the most suitable working angle is reached

• Open the clips on the tripod legs

• Extend the legs to their full length

• Tighten the quick-action locks

3. Near ground level work

• Loosen the lock on the centre column

• Remove the rubber cap from the underside of the centre column

• Slide the centre column out of its holder

• Turn the column around by 180 degree

• Fasten the centre column at a suitable working height

• Fasten the protective cap on the column

4. Removing the quick-release plate

• Press in the locking pin

• Loosen the locking lever for the quick-release plate

5. Locking the ball head

• Use of the locking lever on the ball head

(if the position does not permit locking)

• Pull the locking lever

• Turn it to a suitable position

• Let the lever click into place

• Tighten the ball head

17990uni_man.indd 8 15.10.2013 14:04:00