Owner's Manual
Table Of Contents
- CAUTIONS FOR USE
- WARRANTY AND LIMITATIONS OF LIABILITY
- PACKAGE LIST
- FEATURES
- SPECIFICATIONS
- PREPARING THE INSTA360 ONE RS 1-INCH 360 EDITION FOR USE
- RECOMMENDED CAMERA SETTINGS FOR INSTA360 ONE RS
- CAMERA IN RS360 HOUSING
- PRE-DIVE CHECKLIST
- POST-DIVE CHECKLIST
- START A Recording
- STOP A RECORDING
- CARE AND MAINTENANCE
- TRADEMARKS
- CONTACT
PREPARING THE INSTA360 ONE RS 1-INCH 360 EDITION FOR USE
The Mantis RS360 housing is designed for the Insta360 ONE RS 1-inch Edition
without the mounting bracket. This is so that the domes can be mounted closer to
the lenses for better stitching.
To remove the Insta360 ONE RS 1-inch Edition from the mounting bracket follow
these steps:
1. Open the charge port cover.
2. Push the retaining clips on both sides of the mounting bracket to release the
camera assembly.
3. Slide the camera assembly out of the mounting bracket.
Important: Please confirm the USB-C port plug is installed on the camera’s charge
port before placing the camera into the housing.
The port plug is designed to prevent damage to the battery electronics from water
that may drop into the housing when it is opened. If the port plug is damaged or lost
we recommend covering the charge port with electrical tape.
Please configure the camera with the following settings.
All rights reserved. Information and specifications may change at any time without notice.
Version 1.1, 2023-01-19
6