Specifications

4
33. Maintain a firm footing and good balance, do not
overreach while trimming. Before you start to trim, check
the work area for obstacles that might cause you to lose
your footing, balance or control of the machine. While
operating the machine always be sure of a safe and secure
operating position especially when using steps or a ladder.
Always be sure of your footing on slopes.
WARNING – DANGER
IMPROPER ASSEMBLY OF THIS EQUIPMENT
CAN RESULT IN SERIOUS INJURY. MAKE SURE
TO FOLLOW ALL INSTRUCTIONS CAREFULLY.
IF YOU HAVE ANY QUESTIONS, CONTACT
MANTIS CUSTOMER SERVICE.
34. Always disconnect power cord from power source:
a. Before cleaning blockages.
b. Before checking, cleaning or working on the
cutting portion of the unit.
c. After striking a foreign object: inspect the cutting
part for damage and make repairs before restarting
and operating the unit.
d. If machine starts to vibrate abnormally (check
immediately).
e. Whenever you leave the unit.
35. Securing the extension cord.
Bend the extension cord about 15 inches from the plug
end. Push that bend through the oblong opening in the
back of the handle. Then loop the bend under the cord
retaining clips as shown. This will prevent the extension
cord from detaching from the hedge trimmer plug.
C. Loop Handle Installation
a) Orient the loop half of the handle as shown on the
picture, and place it on the outer shaft of the Power
Head.
Power Head Model Total Weight Power Rating Max Speed Shaft Length
330102 11.8 lbs 850W 8000 RPM 36”
B. Specification
b) Align 4 holes of the second part of the handle with
the holes of the loop half.