Service manual

TROUBLESHOOTINGCOMPACT & ELITE
Problem Possible Solution
LEDs not lit. * Verify power supply is plugged into the stand and into the
power outlet (utility power).
* Verify On/Off switch on stand is turned On.
* Verify that the power cord in the back of the head is plugged in.
* Verify that the power supply is functioning correctly. (Use a
multimeter to measure the output voltage or try using a spare
power supply.)
* Verify that the power outlet that the power supply is plugged
into is functioning properly. (Try plugging in another device to the
same outlet and verify that the outlet is functioning correctly.)
* If the LED arrays were recently replaced, verify that the arrays are
properly installed. (Check all electrical connections to the array.)
* Verify that the On/Off switch is connected inside the Universal
Stand (see separate procedure to check electrical connections).
Poor image quality. * Verify that the Interpupillary Distance adjustment is correct for
the particular user.
* Verify that the front viewing lens is clean. (Use a lens cleaning
cloth.)
* Verify that the objective lens is clean. (Use a lens cleaning cloth.)
* For the Mantis Elite, verify that the objective lenses are installed
flush in the rotary turret.
Head not secure on stand. * Verify that the head mounting bolts are tight.
If using the Bench stand, verify that the rear brace is properly
installed and tight.
Mantis Service Manual www.visioneng.com/support
12
TROUBLESHOOTING
Jean Louis MENEGON - Votre représentant et Conseiller - tél : [phone]
Email: [e-mail] - web: www.menegon-metrologie.com