Specifications

30259-0-0212Page 44
CP (CHILDPROOF) FEATURE
ThisECSremotecontrolincludesaCHILDPROOF“LOCK-OUT”featurethatallowstheuserto“LOCK-OUT”operationofthereplace,
from the TRANSMITTER.
SETTING “LOCK-OUT” –(CP)
• Toactivatethe“LOCK-OUT”feature,pressandholdtheONbuttonandtheMODEbuttonatthesametimefor5seconds.Theletters
CPwillappearintheTEMPframeontheLCDscreen.
• Todisengagethe“LOCK-OUT”,pressandholdtheONbuttonandtheMODEbuttonatthesametimefor5secondsandtheletters
CPwilldisappearfromtheLCDscreenandthetransmitterwillreturntoitsnormaloperatingcondition.
• ToverifythattransmitterisintheCPlock-outmodepressanykeyandtheLCDscreenwillshow“CP”
NOTE:IfthereplaceisalreadyoperatingintheONorTHERMOSTATMODES,engagingthe“LOCK-OUT”will notcanceltheoperating
MODE.Engagingthe“LOCK-OUT”preventsonlythemanualoperationoftheTRANSMITTER.Ifintheautomodes,theTHERMOSTAT
operationwillcontinuetooperatenormally.Tototally“LOCK-OUT”theoperationoftheTRANSMITTER’Soperatingsignals;thetransmit-
ter’sMODEmustbesettoOFF.
THERMOSTAT UPDATING FEATURE –TRANSMITTER – (T/S –TX)
ThisECSremotecontrolhasaTHERMOSTATUPDATINGFeaturebuiltintoitssoftware.TheTHERMOSTATUPDATINGFeatureoper-
atesinthefollowingmanner,butonlyintheTHERMOSTATMODES:
The transmitter normally reads the ROOM temperature every 2 minutes checking the ROOM temperature against the SET tem-
perature and then sends a signal to the receiver.
COMMUNICATION – SAFETY – TRANSMITTER – (C/S – TX)
ThisECSremotecontrolhasaCOMMUNICATION–SAFETYfunctionbuiltintoitssoftware.Itprovidesanextramarginofsafetywhen
theTRANSMITTERisoutofthenormal20footoperatingrangeofthereceiver.
TheCOMMUNICATION–SAFETYfeatureoperatesinthefollowingmanner,inall OPERATING MODES–ON/ONTHERMOSTAT.
AtalltimesandinallOPERATINGMODES,thetransmittersendsanRFsignaleveryfteen(15)minutes,tothereceiver,indicatingthat
thetransmitteriswithinthenormaloperatingrangeof20feet.ShouldthereceiverNOTreceiveatransmittersignalevery15minutes,
theICsoftware,intheRECEIVER,willbegina2-HOUR(120-minute)countdowntimingfunction.Ifduringthis2-hourperiod,thereceiver
doesnotreceiveasignalfromthetransmitter,thereceiverwillshutdownthereplacebeingcontrolledbythereceiver.TheRECEIVER
willthenemitaseriesofrapid“beeps”foraperiodof10seconds.Thenafter10secondsofrapidbeeping,theRECEIVERwillcontinue
toemitasingle“beep”every4secondsuntilatransmitterONorMODEButtonispressedtoresetthereceiver.Theintermittent4-second
beepingwillgoonforaslongasthereceiver’sbatterieslastwhichcouldbeinexcessofoneyear.
To“reset”theRECEIVERandoperatethereplace,youmustpresstheON or MODEbuttononthetransmitter.Byturningthesystem
toON,theCOMMUNICATION-SAFETYoperationisoverriddenandthesystemwillreturntonormaloperationdependingontheMODE
selectedatthetransmitter.TheCOMMUNICATION–SAFETYfeaturewillreactivateshouldthetransmitterbetakenoutofthenormal
operatingrangeorshouldthetransmitter’sbatteriesfailorberemoved.
FRBTC REMOTE INSTRUCTIONS