Specifications

30259-0-0212 Page 39
START UP AND ADJUSTMENTS
A. Withmainelectricalpowertothereplaceturnedoff,install4
AAsized1.5Vbatteriesintotheremotereceiver.Theremote
receiver is located inside the replace, mounted to the top
oftheblowerhousingandsecuredwithhookandlooptape.
SeeFigure70.Setupreceiverandremoteperinstructionson
pages41-46.
RECEIVER LOCATION
ADJ. LEARN
REMOTE ONOFF
Figure 70
B. Turnonthemainelectricalpowertothereplaceandturnthe
mainburnerswitchtotheONposition.SeeFigure71.Verify
powerisonbycheckingifthereispowertothecircuitboard.
Iftheunithaspower,thepowerlightwillbeilluminated.
Figure 71
C. Turnonthemaingassupply.
D. Turnbothburnerswitchesontoigniteboththefrontandrear
burners.BurnerswitchesmustremainintheONpositionfor
the remote to function. See Figure 72.
E. TheDisplayPanelboardshouldbeenergized,andthepower
lightwillbeilluminated.
Sequence of Operations – Front and Back Burners
1. The Display Panel will be energized, and the lights for the
frontburnerandbackburnerwillash.
2. Theinducerwillactivateimmediatelyandwillprovethepres-
sure switch within 16 seconds. This will initiate the ignition
sequence.
3. Therearigniter(HSI)willenergizeandstarttoglowred.
4. Within3to5seconds,thegasvalvewillopenandignitethe
rearburner.Theamesensorwillverifytheameispresent
within2to5seconds.
5. Theigniterfor the frontburner willenergize5 to7 seconds
aftertheameisestablishedontherearburner.
6. Thegasvalvewillopentoignitethefrontburnerwithin3to
5seconds.Theamesensorwillverifytheameispresent
within2to5seconds.
7. AstheMantiswarmsup,thecirculatingblowerwillactivate,
startingonLowspeed.TheLowBlowerL.E.D.willlightwhen
theblowerturnson.
8. AstheMantiscontinuestooperate,thespeedofthecirculat-
ingblowerwillincrease,andtheL.E.D.forMediumandHigh
willappear.
FRONT
BURNER
SWITCH
REAR
BURNER
SWITCH
ECONOMY
DISPLAY
BUTTON
= OFF
=ON
Figure 72
CAUTION
When switching from one burner to the other burner, be
sure to rst turn “ON” the desired burner before turning
“OFF” the burner that is operating. Failure to follow this
sequence may result in the replace needing to be reset.
See page 49 - Resetting the Fireplace.