Owner`s manual

29007-0-0911Page 4
Operating the Heater
Before you start
1. Verifythereiselectricalpowertotheunit.
If electrical power is present, the Power light on the front
control panel will be illuminated. If the Power light is not
illuminated, verify the heater is plugged in and the breaker
and the main power switch are on.
2. Verifythemaingassupplytotheunitison.
The shutoff valve should be in the “OPEN” position.
CLOSED
OPEN
How to Start the Heater – Both Burners
Operating
1. Turn both Front and Rear burner switches to the “ON”
position and adjust the remote thermostat to the de-
sired temperature or press “ON” on the remote. Both
the Front and Rear lights should be illuminated, and the
rear burner light will ash.
2. The light for the Exhaust Fan will illuminate as the heat-
er prepares to ignite.
3. In 15 to 20 seconds, the rear igniter will glow red, and
the burner will light.
4. After the rear burner is lit, the front light will ash and
the igniter will start to glow red and the front burner will
light.
5. The Blower light will illuminate after 3 to 5 minutes. The
blower will automatically advance to a higher speed if
it is needed. The blower speed will be indicated on the
front control panel.