Owner`s manual

27020-3-0410Page 36
Fitting of Hood
Place the hood in the surround as shown in Figure 48 and fasten
with the ve screws and nuts supplied.
Fitting of Surround
Place the surround as shown in Figure 48 on the at front heater
as shown in Figure 49 and fasten to the heater with the four screws
provided at points A, B, C and D.
Note: See page 47 “General Glass Information” for removing and
replacing glass assembly and lower louver.
(A)
(B)
(D)
(C)
FASTENING
POINTS
Figure 48
Figure 49
F(F,I,W)K28(BL,CM,HP,SS)SURROUNDINSTALLATIONINSTRUCTIONS
FGKSURROUNDINSTALLATIONINSTRUCTIONS
Note: If applicable, remove plastic covering from surround.
See Page 16, Figure 14 for rough framing dimensions.
1. Pull Mantis unit out from the wall.
2. Remove three (3) screws from rebox. See Figure 50.
3. Place shield on top of rebox and secure with three (3) screws
removed in step 1.
4. Assemble the surround with eight (8) #10 x 1/2 screws (four
on each side) as shown in Figure 51.
5. Remove two (2) screws from Mantis Control Panel Circuit
Plate. See Figure 52.
6. Use needle nose pliers to remove the six (6) red capped plugs
one at a time from the connectors on the circuit board plate
rocker switch. See Figure 53. After each cable is removed
from the circuit board plate, attach the matching colored ca-
ble on the new wiring harnesses included with the surround
kit. See Figure 54.
7. Using the two (2) screws removed in Step 5, reattach the
Mantis Control Panel Circuit Plate. See Figure 52.
8. Install bushing on left or right side of surround. See Figure
51.
9. Move the surround close to the rebox and thread cable har-
nesses through the bushing on the surround towards the rock-
er switch. See Figure 55.
10. Attach caps to rocker switch. See Rocker Switch Wiring Dia-
gram. See Figure 56. Tuck wires into the rebox.
11. Install rocker switch on same side of surround as bushing.
The switch will be easily accessible from the outside of the
surround. See Figure 51.
SHIELD
FGK SURROUND KIT
REMOVETHESE
SCREWS
CUTOUTONTOP
PANEL FOR SURROUND
PLACEMENT
Figure 50
12. Attach surround to at front replace by lining up the hooks
on the surround with the cutouts on the at front replace
and then pushing down on surround until it locks in place.
See Figure 50. If cutouts are not in the replace top, use the
template included with the kit to create the cutouts.
13. Replace unit into wall.