Owner`s manual

ManualsBrandsMantis ManualsDomestic AppliancesFF28BM-2

27020-3-0410 Page 35

GAS CONNECTION INSTALLATION INSTRUCTIONS

GAS CONNECTION (Line Supply)

A 3/8” Flair gas line connection is supplied in the heater

GAS SUPPLY LINE TO HEATER

1. Pull ex line through top hole in back panel.

2. Connect gas supply line to exible gas hose. Ensure that

exible gas hose is not kinked after tting gas supply

line.

3. Push excess ex line back into heater and place rubber

grommet (supplied in hardware packet) over gas line at

hole to prevent movement.

Figure46

Shown with side removed for clarication.

Note: The gas supply line to the heater must be installed under

conditions which will allow for easy removal of the heater from

its location for servicing of the heater. For replace insert instal-

lations, incorporate either a copper loop into the supply line or

exible hose being used for the gas supply to the heater to allow

for easy removal of the appliance.

Note: Under no circumstances should the gas supply line to the

appliance be installed under conditions, which would not allow

for easy removal of the appliance to carry out routine inspection

and service to the appliance.

GAS CONNECTION INSTALLATION INSTRUCTIONS - IN-WALL UNITS

1. Remove access plate on the left side by removing three

screws as shown in Figure 47.

2. Ppush gas line from back of unit through the access cut out on

the side.

3. Remove the knockout from the access plate and insert gas

line through the hole.

4. Place access plate and secure with three screws removed in

Step 1.

5. Use the plastic plug supplied in the hardware package to plug

the hole in the back of the unit.