Owner`s manual

27020-3-0410 Page 19
FLAT FRONT LOG SET INSTALLATION INSTRUCTIONS
Log Installation
The positioning of the logs is critical to the safe and clean
operation of this heater. Sooting and other problems may result if
the logs are not properly and rmly positioned in the appliance.
Note: Before you begin: Do not handle these logs with your bare
hands! Always wear gloves to prevent skin irritation.
After handling logs, wash your hands gently with soap and
water.
Note: See Page 47 for Glass Assembly removal and
replacement.
Log Placement
1. Place Rear Log (A) onto rear log support. The notch in the
Rear Log ts over the rear Hot Surface Ignitor.
2. Place Left Log (B) on left rear log support shelf. The charred
portion of the log must face inward.
3. Place Middle Log (D) on front log support between the front
and back burners.
4. Place Front Right Log (F) on right side of Firebox bottom.
Notch in bottom of Front Right Log ts over the front Flame
sensor. See Figure 20A.
5. Place Front Left Log (E) on left side of Firebox bottom.
Notch in bottom of Front Left Log ts over front Hot Surface
Ignitor. See Figure 20B.
6. Place Right Log (C) on right rear log support shelf. Top of
log rests on Rear Log (A) and bottom of log rests on Firebox
bottom. Charred portion of log must face inward.
7. Place Left Top Long Log (G) on the pin on Left Log (B). The
upper left leg of Left Top Log will rest on Rear Log (A). The
upper right leg of Left Top Log will rest on Middle Log (D).
8. Place Right Top Long Log (H) on the pin on the Right Log
(C). The bottom left leg of the Right Top Log will rest in the
indent on the right side of the Middle Log (D). The bottom
right leg of the Right Top Log will rest in the indent in the
Front Right Log (F).
Figure 21
REAR LOG SUPPORT
FRONT LOG SUPPORT
FIREBOX BOTTOM
REAR HOT SURFACE IGNITOR
REAR FLAME SENSOR
REAR BURNER
RIGHT REAR
LOG SUPPORT
SHELF
FRONT BURNER
FRONT FLAME SENSOR
FRONT HOT SURFACE IGNITOR
LEFT REAR
LOG SUPPORT
SHELF
Figure 20B
B
F
D
A
H
C
G
E
Figure 20A