Owner`s manual

27020-3-0410Page 18
BAY WINDOW LOG SET INSTALLATION INSTRUCTIONS
Log Installation
The positioning of the logs is critical to the safe and clean opera-
tion of this heater. Sooting and other problems may result if the
logs are not properly and rmly positioned in the appliance.
Note: Before you begin: Do not handle these logs with your
bare hands! Always wear gloves to prevent skin irrita-
tion. After handling logs, wash your hands gently with
soap and water.
1. To access the log set parcel, lift off top panel.
2. Pivot left and right panels open.
3. Unlatch main door latches located on right and left side of the
heater, remove door.
4. Connect Rear Left Log (A) and Rear Right Log (B) at pins on
sides of each log and place in rear of burner. Logs should be
all the way to the back of the rebox.
5. Place Front Left Log (C) into groove on (A) Log and into left
corner of rebox.
6. Place Middle Log (D) over ame sensors in middle of re-
box.
7. Place Front Right Log (E) into right front corner of rebox.
8. Place Top Left Log (F) onto pin on (A) Log. The “legs” of (F)
Log will rest on (D) Log
9. Place Top Right Log (G) onto pin on (B) Log. The “legs” of
(G) Log will rest on (E) Log.
10. Place Door Assembly onto front of heater and latch main
door latches located on right and left sides of the heater.
11. Close left and right panels.
12. Installation of log set is complete.
A
B
C
D
E
Log Placement
Figure 17a
Log Placement
Figure 17b
PLATE - LOG SUPPORT
FRONT HOT SURFACE IGNITOR
REAR HOT SURFACE IGNITOR REAR FLAME SENSOR
FRONT FLAME SENSOR
REAR BURNER
FRONT BURNER
Firebox Layout
Figure 18
F
G
Log Placement
Figure 17c