Installation Guide

9
6.3
Reference: Parts used in this step
6.4
Pass the rod through the end
hole in one of the legs (12), and
then through the small tube
attached to the brace (13).
Pass the open end of the rod
through the other leg (12), slide
the other wheel onto the rod,
and attach it with the axle rod
cap (6b).
Tip: Be sure that the second
wheel is oriented correctly
before attaching cap.
Brace (13)
1 Piece
Small tube
attached to
the brace
2 Pieces
End Holes
Leg (12)
Lift the brace (13) to align the hole in
each fl attened end with the hole in
the handle/leg. Note: The fl attened
end of the brace must be on the
outside of the handle/leg.
6.5
Slide the ends of the handle (11)
over the ends of both legs and align
the holes.
Reference: Part is used in this
step
Handle
End Holes
Handle (11)