Installation Guide

WHAT YOU’LL NEED

Tools: None

Hardware: None

Parts: (1) Door assembly (from step 2)

(1) Drum assembly (from step 4)

WHAT YOU’LL NEED

Tools: Hammer

7/16” wrench

Adjustable wrench

Hardware: 6a - Bolts ¼” x 3-1/4” (6mm x 8.25cm)

6b - Axle rod caps

6c - Axle bushings

6d - Flatwashers 1/4” (6mm)

6e - ¼” Lock nuts

Parts: (1) Drum assembly (from step 4)

Item 9 - (1) Axle rod

Item 10 - (2) Wheels

Item 11 - (1) Handle

Item 12 - (2) Legs

Item 13 - (1) Brace

STEP 5 – DOOR INSTALLATION

STEP 6 – FRAME/DRUM ASSEMBLY

5.1 5.2 5.3

With the door in the OPEN position,

guide the bottom tab into the slot on the

endcap as shown.

Pull the other endcap slightly upward

and guide the other tab into the slot in

the endcap.

Secure the door by hooking the latch

claw into the latch strike and pushing

the latch away from the strike.

Note: The door is designed to be removed to make it easier to ﬁ ll and

empty the ComposTumbler.

Note: Be sure the tabs extend all the way through the endcaps before trying to close the door. As the door closes, these tabs will

rotate and lock themselves into the endcaps. To remove the door, simply reverse the process (open the door, pull up slightly on

the top endcap, and pull the tabs from the endcap slots).

6.1

6.2

Use the hammer to tap an axle rod cap (6b)

onto one end only of the axle rod (9)

Slide one wheel (10) onto the open end of the axle rod.

Note: be sure the axle rod cap ﬁ ts into the “cup” in the

center of the wheel as shown.

Correct Incorrect