Installation Guide

6
WHAT YOU’LL NEED
Tools: Phillips screwdriver
Hardware: 4a - Screws #10 x 1” (2.54cm)
4b - Flat washers 5/16” (8mm)
Parts: Item 1 - (2) Endcaps
(1) Aerator assembly (from step 1)
(1) Front panel (panel with Latch from step 3)
Item 5 - (1) Back panel
STEP 4 – DRUM ASSEMBLY
4.1 4.2
Place one endcap face down (with raised
edge lip facing up) on the ground and
insert the aerator panel assembly into the
channel directly opposite the D-hole vent.
(The posts on the edge of the panel will
mate with the holes in the endcap)
Insert the front panel assembly (with latch)
into the endcap with one end overlapping
the aerator panel assembly making
certain that the edge of the front panel
containing the latch is near the OPEN
area. The open area is for the door.
Here again, the posts on edge of the panel
will mate with the holes in the endcap.
D-Hole Vent
Aerator Panel Assembly
Front Panel
Assembly with Latch
Door Opening