Installation Guide

STEP 1: Aerator Panel Assembly

Select:

• 1 Aerator Panel (large center hole) (item 4)

• 1 Aerator Base (item 7)

• 1 Aerator Cap (item 6)

• 1 Wing Nut (item 16)

• 1 Bolt, 1/4” x 3-1/4” (6 mm x 8.25 cm) (item 17)

1) Insert the 1/4” x 3-1/4” (6 mm x 8.25 cm) Bolt through

the Aerator Cap and position them into the recess on the

inside of the Aerator Panel.

2) Position the Aerator Base, smooth side inward, over the

Bolt and into the recess on the outside of the Aerator

Panel.

3) Thread the Wing Nut onto the end of the Bolt until hand

tight. Be careful not to over-tighten the assembly.

STEP 2: Door Panel Assembly

Select:

• 1 Door Panel (4 holes near one edge) (item 2)

• 1 Latch Strike (item 24)

• 2 Socket Bolts (item 22)

• 2 Screws, #10 (item 23)

• 2 Lockwashers, #10 (item 28)

• 1 Handle (item 26)

• 2 Screws, 5/8” (16 mm) (item 27)

1) From the inside, insert a Socket Bolt through the two

larger center holes in the Door Panel. Place the Latch

Strike against the outside of the Door Panel over the

ends of the Socket Bolts, securing it in position as shown

with Lockwashers and Screws.

2) Attach the Handle to the outside of the Door Panel with

the 5/8” Screws through the outer holes.

STEP 3: Front Panel Assembly

Select:

• 1 Front Panel (2 holes near one edge) (item 3)

• 1 Latch (item 25)

• 2 Socket Bolts (item 22)

• 2 Screws, #10 (item 23)

• 2 Lockwashers, #10 (item 28)

As with the Latch Strike, secure the Latch against the

out side of the Front Panel as shown with the Socket Bolts,

Lockwashers and Screws.